BLOCKWISE Model SGS Simple Band Swager

BLOCKWISE Model SGS Simple Band Swager View Large Image
SGS

The high force model is used for bands that require more force than the standard model. Stainless bands and other similar metals usually require model SGS.

FrequencyDiameter Range:
75 Hz 0.25 to 4mm

Simple model SGS has no automatic product feeder. The operator’s hand slowly feeds the product into the swaging die. Extremely consistent swaged diameter results from patented geometry-controlled (not force-controlled) swaging die mechanism. SGS uses exactly the same swaging mechanism as the automatic feed models. Durability proven in high production at many of the world’s leading catheter makers.

Each swaging die provides one durably precise final swaged band diameter. Dies changeover takes only 2 minutes, with no shimming, adjustment, or calibration required. 

The SGS model are manually fed by the operator. They are a low-cost alternative to the more automated models.

  • Shortest Process Time  Model SGS swages at 75 Hz
  • Most Consistent Band Diameter Because the die fully closes on every blow, the diameter depends only on die geometry, not on any “force” or “pressure” settings, resulting in extremely low diameter variability.
  • Excellent Surface Finish Continuous 360 degree die rotation at 500 rpm for excellent band surface finish.
  • Compact design 60 cm wide by 30 cm deep.
  • Ergonomic Product loaded just above level of worktop.
  • Quick Adjustments Head cover with no hardware, easily changed die.
  • Clean room ready
Clear All

Your Recently Viewed Products

Oops! Something went wrong there and we were unable to load the page you requested.

Sign Up